[Casper] Packages not Verifying w/ 6.0

[Dorey, Dustin]

Not blaming casper remote per say that's just when we noticed the issue.
There is definitely something wrong, but it seems strange as the same
packages worked just fine this morning pre upgrade and now they are not
able to be verified.   This is off of the main casper server using AFP.
And it is actually a number of packages, more than we'd care to rebuild
if we don't have too.   We pulled down one of the problem packages and
we were able to mount and verify it like a normal DMG in finder.    Any
other suggestions?

 

I made a backup of the server before upgrade just in case something went
terribly wrong, I just think this is not one of those cases, seems more
like something is goofy that could probably be fixed pretty easily if we
can figure out the nature of the issue.

Thanks!

 

Dustin Dorey

Technology Support Cluster Specialist

ISD 196 Apple Valley, Rosemount, Eagan

14445 Diamond Path West

Rosemount, MN 55068

(952) 423-7971

dustin.dorey at district196.org

 

From: casper-bounces at list.jamfsoftware.com
[mailto:casper-bounces at list.jamfsoftware.com] On Behalf Of Ernst, Craig
S.
Sent: Friday, July 25, 2008 2:54 PM
To: Casper List
Subject: Re: [Casper] Packages not Verifying w/ 6.0

 

I've been pushing out packages with 6.0 just fine. Just tested it again.
Do all packages do this, have you tried to push another package?

I know that 6.0 has appeared a little more sensitive to corrupt DMG
files than 5.13 has been. I had a package that would just hang Casper
Imaging, but when I tried to mount the DMG manually the OS told me that
some of the information might be corrupt. I rebuilt the pack and all is
fine.

I'm also using an SMB share. What type of distribution point are you
using? Are you using the new HTTP stuff or what you had before?

I especially like the percentage status of the install per package with
Casper Remote!

I wouldn't out right blame Casper Remote...

Craig E


On 7/25/08 2:43 PM, "Dorey, Dustin" <Dustin.Dorey at district196.org>
wrote:

Hey there folks,
Well we took the jump, upgraded to 6.0 everything seemed fine.   But
when we try to push stuff with Casper Remote it fails.  When we go to
the log on the failed push it  says it is failing when it tries to
Verify the DMG.
 
 
  Verifying DMG...   
  Error: The downloaded package could not be verified.   
  Enforcing Management Framework...   
  The Management Framework will be enforced as soon as all Policies are
done executing  
 
 
Any ideas?  Probably something simple. 
Thanks everyone!
 
Dustin Dorey
Technology Support Cluster Specialist
ISD 196 Apple Valley, Rosemount, Eagan
14445 Diamond Path West
Rosemount, MN 55068
(952) 423-7971
dustin.dorey at district196.org
 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://list.jamfsoftware.com/pipermail/casper/attachments/20080725/ceda0810/attachment.html