[Casper] Packages not Verifying w/ 6.0

[Ernst, Craig S.]

I wish I had more suggestions, but it sounds like you've done the basic things I'd check for.

Wish I could be more helpful. =/

Craig E


On 7/25/08 3:02 PM, "Dorey, Dustin" <Dustin.Dorey at district196.org> wrote:

Not blaming casper remote per say that's just when we noticed the issue.      There is definitely something wrong, but it seems strange as the same packages worked just fine this morning pre upgrade and now they are not able to be verified.   This is off of the main casper server using AFP.    And it is actually a number of packages, more than we'd care to rebuild if we don't have too.   We pulled down one of the problem packages and we were able to mount and verify it like a normal DMG in finder.    Any other suggestions?

I made a backup of the server before upgrade just in case something went terribly wrong, I just think this is not one of those cases, seems more like something is goofy that could probably be fixed pretty easily if we can figure out the nature of the issue.
Thanks!


Dustin Dorey
Technology Support Cluster Specialist
ISD 196 Apple Valley, Rosemount, Eagan
14445 Diamond Path West
Rosemount, MN 55068
(952) 423-7971
dustin.dorey at district196.org


From: casper-bounces at list.jamfsoftware.com [mailto:casper-bounces at list.jamfsoftware.com] On Behalf Of Ernst, Craig S.
Sent: Friday, July 25, 2008 2:54 PM
To: Casper List
Subject: Re: [Casper] Packages not Verifying w/ 6.0

I've been pushing out packages with 6.0 just fine. Just tested it again. Do all packages do this, have you tried to push another package?

I know that 6.0 has appeared a little more sensitive to corrupt DMG files than 5.13 has been. I had a package that would just hang Casper Imaging, but when I tried to mount the DMG manually the OS told me that some of the information might be corrupt. I rebuilt the pack and all is fine.

I'm also using an SMB share. What type of distribution point are you using? Are you using the new HTTP stuff or what you had before?

I especially like the percentage status of the install per package with Casper Remote!

I wouldn't out right blame Casper Remote...

Craig E


On 7/25/08 2:43 PM, "Dorey, Dustin" <Dustin.Dorey at district196.org> wrote:
Hey there folks,
Well we took the jump, upgraded to 6.0 everything seemed fine.   But when we try to push stuff with Casper Remote it fails.  When we go to the log on the failed push it  says it is failing when it tries to Verify the DMG.


  Verifying DMG...
  Error: The downloaded package could not be verified.
  Enforcing Management Framework...
  The Management Framework will be enforced as soon as all Policies are done executing


Any ideas?  Probably something simple.
Thanks everyone!

Dustin Dorey
Technology Support Cluster Specialist
ISD 196 Apple Valley, Rosemount, Eagan
14445 Diamond Path West
Rosemount, MN 55068
(952) 423-7971
dustin.dorey at district196.org


-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://list.jamfsoftware.com/pipermail/casper/attachments/20080725/c798a157/attachment.htm