[Casper] Imaging Macs

[James Alcasid]

You should have these setting built into your baseline image.

Enable Remote Login and Remote Management and create an account below 501 in
your baseline. I am sure there are better ways to do it but that is a start.


-- 

James Alcasíd, ACSA | VeriSolv Technologies
Department of Veterans Affairs | Enterprise Infrastructure Engineering
470 L¹Enfant Plaza Suite 3100, Washington DC 20024
Office (202) 245-4573

Note:
This message is for the named person's use only.  It may contain
confidential, proprietary or legally privileged information.  No
confidentiality or privilege is waived or lost by any mis-transmission.  If
you receive this message in error, immediately delete it and all copies of
it from your system, destroy any hard copies of it and notify the sender.
You must not, directly or indirectly, use, disclose, distribute, print, or
copy any part of this message if you are not the intended recipient.  Any
views expressed in this message are those of the individual sender, except
where the message states otherwise and the sender is authorized to state
them to be the views of any such entity.


> From: Jade Curtis <jcur at loc.gov>
> Date: Sun, 27 Sep 2009 12:08:26 -0400
> To: <casper at list.jamfsoftware.com>
> Subject: [Casper] Imaging Macs
> 
> I have been working on setting up some MacBooks.
> I first turn on SSH and then make the user account change the login options.
> I then use Casper Imaging to install the software. Is there away to have set
> SSH, ARD and make a user and chug login options during Imaging? Or what is
> best to do before imaging?
> _______________________________________________
> Casper mailing list
> Casper at list.jamfsoftware.com
> http://list.jamfsoftware.com/mailman/listinfo/casper